It may seem that footpegs are just a basic item. How could a "footpeg" be improved upon? Well, if anybody could do it, it would be Doug Roll. Ever since we first saw a set of these pegs, we knew we had to have them for our Project 400EX.

These pegs have a patented three-rung design that makes the peg over 2 1/2" wide. They are available in a flat design or "kick up" (with a flipped-up outer edge). The pegs are made from 17-4 cast stainless steel, and then delivered with a powder coated-polished finish. These are going to stay sharp and last longer than any aluminum peg.

Installation couldn't be simpler

Remove two bolts on the peg and one holding the heel plate, and your stock stuff is outta there.

Using your stock bolts, attach the new IMS pegs.

How do they look?

Summary

We have been logging many miles in the desert the last few weeks getting ready for the BITD Las Vegas 200. We love these pegs. Not once have we slipped off them or even felt like we were going to slip off them. Not only do they work well, but we like the looks too! Yes, they are a little pricey at $239 bucks a pair, but with Christmas coming up, what the heck, even if you have to buy them for yourself... Available for models:
Honda Trx250r,400ex,300ex.
Yamaha: Banshee, Raptor, Blaster, Warrior.
Bombardier: DS650

MSRP is $229.95, with kick-up will run you $239.95 a pair

IMS Products
6240 Box Springs Blvd. Unit E.
Riverside, CA 92507
Telephone: 909-653-7720 Fax: 909-653-1060
Toll Free: 800-237-9906
www.IMSProducts.com